Val V

Val V

  • Commented on Raymarine AIS350 and es97 display
    Thanks Ben for the detailed (and patient) response. Much appreciate it. You make a great point that if MFD doesnt need to send anything to the AIS then why 'OUT'. I dont know and I will definitely try it. And...
  • Commented on Raymarine AIS350 and es97 display
    After posting this I may have found the answer. I will not know until I go back on the boat next week. AIS manual says "orange and brown", "orange and yellow", etc. Perhaps they are referring to some other wire...
  • Commented on Raymarine AIS350 and es97 display
    Thanks Ben for responding. Unfortunately when I tried to connect Ray AIS350 to Ray eS97 display via NMEA0183 I ran into unexpected problem. AIS manual describes this type of connection as: 1 Green <> Orange/Brown 2 White <> Orange/yellow 3...
  • Commented on Raymarine AIS350 and es97 display
    I have. About SeaTalk the manual states I need to use either 5 way connector *OR* T-piece connector *OR* spare SeaTalk spur on a SeaTalk converter. The manual assumes I have a large network of these seatalk devices. It does...
  • Commented on Raymarine AIS350 and es97 display
    I suppose I can try NMEA0183 which comes out of power cable on both AIS and the display unit. That should bypass SeaTalk. Correct? And if so would I need to supply any additional power to that?...
  • Commented on Raymarine AIS350 and es97 display
    Just called to verify again. They confirmed in a single SeaTalk device installation I do not need anything else. The spur cable can go directly from the AIS350 into the es97 display. I told him that something isnt working and...
  • Posted Raymarine AIS350 and es97 display to Panbo Forum
    Really hoping someone could help since Raymarine support suggestion only extended to resetting everything to factory defaults. I have eS97 Raymarine display which is about 1 year old. Latest LightHouse v19.x. Recently I purchased Raymarine AIS350 receiver which is the...
Subscribe to feed Recent Actions from Val V